Automatically build standard products in SOLIDWORKS with TSFP.
Search for standard products in the TSFP catalog.
ISO 8738 - Plain washers for clevis pins, product grade A
Plain washers for clevis pins, product grade A, replacing DIN 1440: the hole still equals the pin diameter, but there are fewer sizes and most outside diameters from size 8 up are smaller. For use with ISO 2340 and ISO 2341 clevis pins on the cotter pin end.
DIN 125 - Flat washers
Withdrawn German standard for plain washers, normal series, replaced by ISO 7089: the shared sizes match up to M36, from M39 the holes are narrower, and the range is wider, M1 to M100. From M42 some washers are also thinner than in ISO 7089.
Outdated standard
DIN 126 - Product grade C washers for hexagon head bolts and nuts
Plain round washers, product grade C, to withdrawn DIN 126:1990-03, designated by the hole diameter. DIN 126 retains M7 and sizes above M64, unlike ISO 7091; washers for M42 and M45 are 7 mm thick.
Outdated standard
DIN 1440 - Washers for clevis pins, product grade A
Withdrawn washers for clevis pins, product grade A, medium finish, with a hole equal to the pin diameter, where DIN 1441 has the same outside diameters and thicknesses but a wider hole. The nominal size is the pin diameter, not a thread size. Replaced by DIN EN 28738 / ISO 8738, which is not dimensionally identical in all sizes.
Outdated standard
DIN 433-1 - Plain small-series washers, hardness up to 250 HV
Plain small-series washers to withdrawn DIN 433-1:1990-03, hardness up to 250 HV, designated by the hole diameter. M18 washers are 2.5 mm thick and M36 washers have an outside diameter of 58 mm, unlike ISO 7092. DIN 433-2 specifies the internally chamfered form.
Outdated standard
DIN 440 R - Washers with round hole for timber constructions
Withdrawn extra large series washers with a round hole, mainly for timber constructions, dimensionally identical to their replacement ISO 7094 from M5 to M36. Product grade C, hardness class 100 HV. The 1990 edition covers M5 to M52. Form V of DIN 440 has a square hole.
Outdated standard
DIN 9021 - Plain washers, large series, product grade A
Withdrawn plain washers, large series, product grade A, the predecessor of ISO 7093-1, which drops sizes 2.5 and 7 and has narrower holes from size 18. The outer diameter is about three times the inner diameter.
Outdated standard